Help
I did not understand how I have to mark allowance. I have to type 0?
allowance truth in what is
allowance
- GripUs
- Vectric Wizard
- Posts: 806
- Joined: Thu Jan 18, 2007 2:07 pm
- Location: San Angelo, Texas
- Contact:
Re: allowance
Hello gcioffi,
Allowance is the amount of material left after you have run your roughing pass. Since you usually use a smaller bit for the finish pass, you want it to work less by machining less material so you set it to something small. I think the default is ".04" and I find that works just fine in most cases.
Regards,
Joe
Allowance is the amount of material left after you have run your roughing pass. Since you usually use a smaller bit for the finish pass, you want it to work less by machining less material so you set it to something small. I think the default is ".04" and I find that works just fine in most cases.
Regards,
Joe
Ham and eggs - Inconvenient for the chicken. A total commitment for the pig.
http://www.gripus.com/
http://www.gripus.com/
Re: allowance
ok thanks
now is ok
mi have test today 0 allowance, wait result job
now is ok
mi have test today 0 allowance, wait result job