I am looking for something to do

This section is for general discussion about Gadgets
dyn0bill
Posts: 36
Joined: Sun Feb 21, 2021 8:10 am
Model of CNC Machine: EZ Route 4x8/WinCNC
Location: Williamstown, WV

Re: I am looking for something to do

Post by dyn0bill »

Well,
I am using EasyCabinetMakerVer11.4 to make a cabinet. I can't seem to get the text where I can read it. Also it would be nice if it fit the job size and use layers.

Attached are snips of the issues.

Thanks again,
Willy
Attachments
Text in a pile
Text in a pile
Parts that don't fit on a 4x8 piece of plywood.
Parts that don't fit on a 4x8 piece of plywood.

User avatar
jimandi5000
Vectric Wizard
Posts: 736
Joined: Wed Mar 11, 2015 6:50 pm
Model of CNC Machine: Home Made 60 x 120
Location: North Houston Tx.

Re: I am looking for something to do

Post by jimandi5000 »

dyn0bill wrote:
Mon Sep 27, 2021 11:16 pm
Well,
I am using EasyCabinetMakerVer11.4 to make a cabinet. I can't seem to get the text where I can read it. Also it would be nice if it fit the job size and use layers.

Attached are snips of the issues.

Thanks again,
Willy

Hi Willy,

Thanks for letting me know about this issue. I will have a look at it in the morning and I will post an update ASP.
Thanks,
Jim

pviljoen
Posts: 8
Joined: Mon Jul 19, 2021 9:14 pm
Model of CNC Machine: AvidCNC

Re: I am looking for something to do

Post by pviljoen »

I have a question for you. How would I design the gears to run on the inside of a ring. Looks like the gear gadget only works for gears on the outside. The question is similar to the latest free monthly projects of Spiro Drawing board.

User avatar
adze_cnc
Vectric Apprentice
Posts: 2014
Joined: Sat Jul 27, 2013 10:08 pm
Model of CNC Machine: AXYZ 4008
Location: Vancouver, BC, Canada

Re: I am looking for something to do

Post by adze_cnc »

For gears you might check FixitMike's article: viewtopic.php?t=21084

As well his posts earlier in this thread: viewtopic.php?p=278169#p278169

pviljoen
Posts: 8
Joined: Mon Jul 19, 2021 9:14 pm
Model of CNC Machine: AvidCNC

Re: I am looking for something to do

Post by pviljoen »

Thank you. much appreciated.

Post Reply