I make all kinds of gadgets. Frequently I have to drill
hole pattern to mount a stepper, or servo motor.
Most of the time I draw a box the size of the motor holes
and put circles (holes) centered on the corners.
See attached file.
My question is there a function that will center the circles
(holes) on the corners?
I'm sure it's right in front of me.
Thanks for any help!!
olf20 / Bob
Align holes to square
Align holes to square
- Attachments
-
- TestMtg.crv
- (20.5 KiB) Downloaded 105 times
Heat with corn, Mach3, Bridgeport clone, VcarvePo, Photo VCarve, Craftsman Wood Lathe, Arduino Toys
- mtylerfl
- Vectric Archimage
- Posts: 5865
- Joined: Thu Jan 29, 2009 3:54 am
- Model of CNC Machine: -CarveWright CNC -ShopBot Buddy PRSAlpha
- Location: Brunswick, GA
Re: Align holes to square
Hi,
I would just turn on the Snap to Geometry feature, and drag the circles from their center-points to the corners (they will automatically snap to the corner - no fuss, no muss).
NOTE: If the square is centered in the job, you can just drag/snap ONE circle, then use the short cut keys Ctrl+Shift+H and Ctrl+Shift+V to copy that circle to the square's other three corners horizontally and vertically as appropriate.
I would just turn on the Snap to Geometry feature, and drag the circles from their center-points to the corners (they will automatically snap to the corner - no fuss, no muss).
NOTE: If the square is centered in the job, you can just drag/snap ONE circle, then use the short cut keys Ctrl+Shift+H and Ctrl+Shift+V to copy that circle to the square's other three corners horizontally and vertically as appropriate.
Michael Tyler
facebook.com/carvebuddy
-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC
facebook.com/carvebuddy
-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC
Re: Align holes to square
I knew about that but for some reason I never
tried it for that particular function.
Thanks for the quick reply!!
olf20 / Bob
tried it for that particular function.
Thanks for the quick reply!!
olf20 / Bob
Heat with corn, Mach3, Bridgeport clone, VcarvePo, Photo VCarve, Craftsman Wood Lathe, Arduino Toys
- mrmfwilson
- Vectric Craftsman
- Posts: 239
- Joined: Thu May 31, 2012 6:49 pm
- Model of CNC Machine: Legacy Arty 36
- Location: Georgetown, TX
Re: Align holes to square
Another way would be to use the Array Copy command. Draw one circle and Array Copy the circle. For 4 circles use; 2 Columns and 2 Rows. Set the spacing to Offset and enter the center to center offset distance. The offset distance can be different for X (Rows) and Y(columns) if needed.
Mr. Wilson
CenterLine Designs
Facebook - Centerline Designs
CenterLine Designs
Facebook - Centerline Designs
Re: Align holes to square
And yet I keep learning!
I have use array but not
exactly that way.
Thanks guys.
olf20 / Bob
I have use array but not
exactly that way.
Thanks guys.
olf20 / Bob
Heat with corn, Mach3, Bridgeport clone, VcarvePo, Photo VCarve, Craftsman Wood Lathe, Arduino Toys