Gravograph Compatibility

This section is for useful tips and tricks for Aspire
Post Reply
DougN
Vectric Apprentice
Posts: 4
Joined: Sun May 14, 2017 2:33 pm
Model of CNC Machine: Stepcraft 840

Gravograph Compatibility

Post by DougN »

I have recently acquired a used Gravograph M40. The software for this is primal at best. After numerous attempts contacting Gravograph and their so-called representative for the last two months I have not received any acknowledgement at all. In all fairness I have found their tech support to be excellent.

Running Aspire, I have noticed drivers for other Gravograph equipment. To use Aspire for the M40 would be great. Any drivers for the M40 machine?

Thanks in advance.

User avatar
Adrian
Vectric Archimage
Posts: 10722
Joined: Thu Nov 23, 2006 2:19 pm
Model of CNC Machine: ShopBot PRS Alpha 96x48
Location: Surrey, UK

Re: Gravograph Compatibility

Post by Adrian »

As long as the control software is the same as the other models the Gravograph drivers should work I would think. It's not the hardware that the output from the Vectric software operates with it's the control software.

DougN
Vectric Apprentice
Posts: 4
Joined: Sun May 14, 2017 2:33 pm
Model of CNC Machine: Stepcraft 840

Re: Gravograph Compatibility

Post by DougN »

I'll have to play with it for a bit. Thanks for the reply.

Post Reply