2-Sided Prototype in RenShape

This is the place to post images of work produced using Aspire
Post Reply
fredfow3
Vectric Apprentice
Posts: 55
Joined: Thu Aug 04, 2016 1:40 am
Model of CNC Machine: Laguna Swift 4x4, Shapeoko S3 XL
Location: Massachusetts
Contact:

2-Sided Prototype in RenShape

Post by fredfow3 »

Hey all,

Just finished a 2-sided model for a customer. 1st time using RenShape and I love it! Cuts great and very accurate. No finishing was needed.

Thought i'd share a couple of pix.
Top Side
Top Side
Bottom Side
Bottom Side
Cheers!

Fred

CarveOne
Vectric Wizard
Posts: 1391
Joined: Sun Nov 28, 2010 5:10 pm
Model of CNC Machine: Home built designs - 3'x4' and 5'x12'
Location: Eastern NC, USA
Contact:

Re: 2-Sided Prototype in RenShape

Post by CarveOne »

I have worked with a friend for many years to make fiberglass "skin" lay-ups that use RenShape 440 material that was machined by a contract company with a large ShopBot CNC router. When I home-built my two CNC machines after retiring, I cut some some molds for some of his R/C models, wind tunnel models for commercial and military projects, and UAV/RPV projects. It does carve well, and when finished properly, can make very accurate surfaces for the lay-ups. I still help him out some when he gets behind on a project. Some of the wing panels are 10 feet long and require some heavy lifting to move the molds around in his shop. Fun work though.

CarveOne
CarveOne
http://www.carveonecncwoodcraft.com

Post Reply