I can't upload the file, as its too big, but as in the pics, they are clearly there.
But when calculated, and shown in preview, they are not. Not sure what I'm missing here?
Tabs not getting added?
- Mogal
- Vectric Craftsman
- Posts: 238
- Joined: Wed Oct 13, 2010 5:28 pm
- Model of CNC Machine: DIY CNC
- Location: Victoria, BC
- Contact:
Re: Tabs not getting added?
I had to delete all the tool paths, save and reload, remake toolpaths, now its generating tabs...
Dunno what happened, but its working now.
Dunno what happened, but its working now.
- martin54
- Vectric Archimage
- Posts: 7352
- Joined: Fri Nov 09, 2012 2:12 pm
- Model of CNC Machine: Gerber 48, Triac PC, Isel fixed gantry
- Location: Kirkcaldy, Scotland
Re: Tabs not getting added?
Sure I read a post on here a while ago where someone had problems with tabs not showing & the solution was to increase the toolpath preview resolution, if it happens again might be worth increasing your toolpath resolution to see if they show up in the preview
Won't help this time but next time it might save you a bit of work.
Won't help this time but next time it might save you a bit of work.
- zeeway
- Vectric Wizard
- Posts: 3157
- Joined: Thu Feb 11, 2010 9:24 pm
- Model of CNC Machine: Self-built
- Location: SC, USA
Re: Tabs not getting added?
My guess is that you had a toolpath that cut through the tabs, initially.
Re: Tabs not getting added?
I may be wrong but, seems to me that the tabs were added to a wrong circle.