Bass Kit body with carvings

This is the place to post images of work produced using Aspire
Post Reply
User avatar
galerdude
Vectric Apprentice
Posts: 176
Joined: Sun Dec 12, 2010 7:39 am
Model of CNC Machine: Joe's 4x4 Hybrid R&P Evolution
Location: Spokane, WA USA

Bass Kit body with carvings

Post by galerdude »

Finally finished up this bass kit I'd had for a year and a half :roll: with some carvings. Main intent is to take it camping and such and not worry about dingin' it up. Fun project!
IMG_20160803_145252714-2.jpg
IMG_20160803_145417992-2.jpg
Regards,
Gale

MTSO
Vectric Craftsman
Posts: 260
Joined: Tue Mar 11, 2014 6:12 pm
Model of CNC Machine: salecnc XJ1224
Location: Auckland New Zealand

Re: Bass Kit body with carvings

Post by MTSO »

cool mate love the carving on the back, how long did it take to carve?.

regards

Brian

User avatar
galerdude
Vectric Apprentice
Posts: 176
Joined: Sun Dec 12, 2010 7:39 am
Model of CNC Machine: Joe's 4x4 Hybrid R&P Evolution
Location: Spokane, WA USA

Re: Bass Kit body with carvings

Post by galerdude »

MTSO wrote:cool mate love the carving on the back, how long did it take to carve?.

regards

Brian
Thanks Brian!
I run stuff pretty slow so please take that into account;
1 - Approximately an hour (V-carve) clearing with .125" end mill @ 80 ipm; .1" deep.
2 - Almost 4 hours V-carving with 60 degree laser bit @ 60 ipm; .1" deep.

Thanks again for the comment!
Regards,
Gale

cabnet636
Vectric Wizard
Posts: 2583
Joined: Fri Dec 21, 2007 1:57 am
Model of CNC Machine: CAMaster 508 ATC
Location: columbia sc
Contact:

Re: Bass Kit body with carvings

Post by cabnet636 »

Very Nice !
James McGrew
http://www.mcgrewwoodwork.com
CAMaster ATC 508 24/7 http://dropc.am/p/EJaKyl

User avatar
galerdude
Vectric Apprentice
Posts: 176
Joined: Sun Dec 12, 2010 7:39 am
Model of CNC Machine: Joe's 4x4 Hybrid R&P Evolution
Location: Spokane, WA USA

Re: Bass Kit body with carvings

Post by galerdude »

cabnet636 wrote:Very Nice !
Thank You, very much, James!
Regards,
Gale

User avatar
galerdude
Vectric Apprentice
Posts: 176
Joined: Sun Dec 12, 2010 7:39 am
Model of CNC Machine: Joe's 4x4 Hybrid R&P Evolution
Location: Spokane, WA USA

Re: Bass Kit body with carvings

Post by galerdude »

Thank You Vectric!
I am very humbled and honored that you included this project in your newsletter!
Regards,
Gale

Post Reply