Problems with final product
-
- Posts: 13
- Joined: Sun Nov 02, 2014 5:41 am
- Model of CNC Machine: Shark HD
Re: Problems with final product
Thanks, set the machine strategy to Raster and no line.... very strange indeed....'
-
- Vectric Craftsman
- Posts: 240
- Joined: Sun May 15, 2011 4:19 pm
- Model of CNC Machine: Camaster Stinger II
Re: Problems with final product
Perhaps not, but it appears he is cutting a negative of the model - either there is an incorrect measurement of the material being cut or the setup is fouled somehow.
- Mike-S
- Vectric Wizard
- Posts: 1123
- Joined: Mon Jun 13, 2011 6:45 am
- Model of CNC Machine: Joe's Hybrid 4x4 (but 3x3)
- Location: Hayesville, NC
Re: Problems with final product
Optical illusion because of lower left lighting and rotated picture, it's a normal carve.it appears he is cutting a negative of the model
I tried to duplicate and I believe you lost some Z steps during the carve. Since the middle zone is cut last, the change in Z showed up in that area.