new tool
-
- Posts: 1
- Joined: Sun Feb 21, 2016 6:28 pm
- Model of CNC Machine: routakit HD
new tool
I am tring to add a new tool that is ment so level my spoil board the tool shape is the one on the left but the one on the right will import but will it cause the correct cut
- Rcnewcomb
- Vectric Archimage
- Posts: 5915
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
- Contact:
Re: new tool
Just set it up as an end mill
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop
10 fingers in, 10 fingers out, another good day in the shop
- martin54
- Vectric Archimage
- Posts: 7349
- Joined: Fri Nov 09, 2012 2:12 pm
- Model of CNC Machine: Gerber 48, Triac PC, Isel fixed gantry
- Location: Kirkcaldy, Scotland
Re: new tool
Set it up as a normal endmill as Randall has already suggested, when you are using it you would be best to ramp into material rather than try plunging as it doesn't look to cut the full bottom of the tool from your enclosed pictures.