Filets
-
- Posts: 17
- Joined: Fri Oct 25, 2013 3:08 pm
- Model of CNC Machine: CAMaster Stinger I WinCNC Aspire 8
Filets
Is there a way to create fillets with Aspire on acute angles ? Or is it just a 90* angle option ?
- Mike-S
- Vectric Wizard
- Posts: 1123
- Joined: Mon Jun 13, 2011 6:45 am
- Model of CNC Machine: Joe's Hybrid 4x4 (but 3x3)
- Location: Hayesville, NC
Re: Filets
If the vectors are straight and connected, you should have no problem with acute angles.
-
- Vectric Wizard
- Posts: 520
- Joined: Tue Jul 21, 2009 8:22 pm
- Model of CNC Machine: ShopBot Buddy Standard
- Location: Marietta, GA.
Re: Filets
Fillets or radiuses can be added interactively at points where any two straight lines meet......joe
-
- Posts: 17
- Joined: Fri Oct 25, 2013 3:08 pm
- Model of CNC Machine: CAMaster Stinger I WinCNC Aspire 8
Re: Filets
Thanks fellas , seems I was using to big of a radius on my fillets when I tried this , now that I have them properly sized it works just fine .
- FixitMike
- Vectric Wizard
- Posts: 2176
- Joined: Sun Apr 17, 2011 5:21 am
- Model of CNC Machine: Shark Pro Plus (retired)
- Location: Burien, WA USA
Re: Filets
Note that if there is a node (other than the corner) on either of the lines that the fillet would eliminate, the tool will not work. Also, if you already have a profile toolpath for the lines with tabs, recalculating after adding a fillet may cause the tabs to change location.
Good judgement comes from experience.
Experience comes from bad judgement.
Experience comes from bad judgement.
-
- Posts: 17
- Joined: Fri Oct 25, 2013 3:08 pm
- Model of CNC Machine: CAMaster Stinger I WinCNC Aspire 8
Re: Filets
Thanks Mike , was not aware of nodes causing the tool not to work , I'll keep that in mind