I've been posting these to Facebook, but haven't here yet.
This is an ongoing project to effectively transform a photo to a true 2.5d carving from 3/4" to 1 1/4" in depth.
photo to engraving
-
- Posts: 3
- Joined: Mon Dec 01, 2014 2:12 pm
- Model of CNC Machine: shopbot prsalpha 60x96
-
- Vectric Craftsman
- Posts: 208
- Joined: Sun Jan 26, 2014 12:59 pm
- Model of CNC Machine: CAMMaster Stinger II
- Location: Romney, WV
Re: photo to engraving
Nice, have you carved one yet? How large will the finished project be?
- Creation in Wood
- Vectric Wizard
- Posts: 856
- Joined: Thu May 28, 2015 8:58 pm
- Model of CNC Machine: Legacy Maverick ATC 4x8 CNC
- Location: Monument, Colorado USA
Re: photo to engraving
Nice project. I have been trying to figure out how to do a photo carve of my niece.
What process did you use to create the 3d Carved image?
What process did you use to create the 3d Carved image?
Thank You
Doug
Doug
-
- Vectric Wizard
- Posts: 1013
- Joined: Fri May 15, 2015 1:10 pm
- Model of CNC Machine: 3 axis small size machine
- Location: France
Re: photo to engraving
Hi,
Same question as Doug.
As I understand it, you have a specific process to transform any picture into a 3D bas-relief?
Or did you "simply" use the usual process of bas-relief designing in Aspire?
Same question as Doug.
As I understand it, you have a specific process to transform any picture into a 3D bas-relief?
Or did you "simply" use the usual process of bas-relief designing in Aspire?
Best regards
Didier
W7 - Aspire 8.517
Didier
W7 - Aspire 8.517