Carving of a Picture

This section is for useful tips and tricks for Aspire
Post Reply
drandals
Posts: 9
Joined: Thu Sep 02, 2010 4:28 pm

Carving of a Picture

Post by drandals »

I am trying something I've never do before. Trying to take a picture and carve the image. I have used the smoothing option, but is there a way to reverse the depths. Example, the nose in instead of out, eyes out instead of in. I'm sure its simple and I am overlooking or where can I see a tutorial on it? Thanks

User avatar
Rcnewcomb
Vectric Wizard
Posts: 3970
Joined: Fri Nov 04, 2005 5:54 am
Model of CNC Machine: GCnC/WinCNC
Location: San Jose, California, USA
Contact:

Re: Carving of a Picture

Post by Rcnewcomb »

Look at the Trout tutorial under 3D modeling.
- Randall Newcomb
10 fingers in, 10 fingers out
another good day in the shop

Pete Cyr
Vectric Craftsman
Posts: 197
Joined: Sun May 15, 2011 4:19 pm
Model of CNC Machine: Camaster Stinger II

Re: Carving of a Picture

Post by Pete Cyr »

select combine mode of subtract

Post Reply