Newbie questions!

This forum is for general discussion regarding VCarve Pro
Post Reply
GVP
Posts: 10
Joined: Tue Jun 06, 2006 12:28 am
Location: Saskatchewan, Canada

Newbie questions!

Post by GVP »

Hello,

I'm getting to grips with V-Carve wizard and cnc routing in general!

My first test cut has the tool scoring the top surface of the substrate - I notice in VCW the "Safe Z" is reading quite small 0.0394". How is this figure calculated, and is there a means to adjust it? Or if I'm on the wrong tack altogether, what should I be doing instead?

Any help appreciated!

User avatar
Tony Mac
Vectric Alumni
Posts: 1965
Joined: Sat Jul 30, 2005 6:24 pm
Location: UK
Contact:

Post by Tony Mac »

Hello GVP,

In VCarve Wizard the Rapid Clearance Gap = SafeZ height.

This is specified on the Material Setup form which is the 1st icon on the Toolpath Tab as shown below.

Let us know if you need further assistance.

Tony
Attachments
Form.jpg
Form.jpg (13.39 KiB) Viewed 314 times
Setup_Material.jpg
Setup_Material.jpg (8.34 KiB) Viewed 624 times

Post Reply