Forgive me if not in the right place but after looking at cnczone i think my head would explode with the choices before i wrote my question
![Smile :)](./images/smilies/icon_smile.gif)
So, as i am new here and setup with high-z 730, my wood in place and i need the cuts to be accurate (obviously) i put the first mill in the router and set my xyz start zero point
I understand resetting the z each time i change the tool but i got to thinking, surely my xy zero must change fractionally from when i use a large clearing tool to a smaller finishing tool due to teh diameter differences, so how do i get the centre of the tool exactly at the zero point each time?
thanks
malc