Defining tapered endmills

This section is for useful tips and tricks for Aspire
Post Reply
LonePine
Vectric Craftsman
Posts: 117
Joined: Tue Jan 03, 2012 2:45 pm
Model of CNC Machine: Laguna Tools IQ pro

Defining tapered endmills

Post by LonePine »

Hi,

Is there a thread on the forum that discusses how to define tapered endmills?

Example: if I'm using a tapered endmill 1/4" shank to 1/8" ballend, do I simply define it as a 1/8" ballend. (In other words always just define the bit in terms of the tip, and forget the taper?)

User avatar
Adrian
Vectric Archimage
Posts: 10255
Joined: Thu Nov 23, 2006 2:19 pm
Model of CNC Machine: ShopBot PRS Alpha 96x48
Location: Surrey, UK

Re: Defining tapered endmills

Post by Adrian »

Personally I always set them up as straight ballnoses as the types of 3D work I do with them only uses the tip.

However you could use the Tapered Ballnose tool type but you'd need to work out the side angle.

User avatar
Leo
Vectric Wizard
Posts: 3034
Joined: Sat Jul 14, 2007 3:02 am
Model of CNC Machine: 1300 x 1300 x 254 Chinese Made
Location: East Freetown, Ma.
Contact:

Re: Defining tapered endmills

Post by Leo »

I wet through the trouble to draw the tool.

1/8 ball

1/4 shank

Length of taper on mine is 1"

So - I drew a 1/8 ball and a 1/4 shank

I laid out the 1" taper length

I drew a line tangent to ball and to intersection of cut depth.

I drew a line for the center line of the cutter - then trimmed the ball

I trimmed all un-needed lines.

That's the HARD way. :lol:

At the time I did that - I was not aware of the easy way. :oops:

The easy way is the use the tapered ball nose mill tool in the database.
The angle should be available from the manufacturer.
Imagine the Possibilities of a Creative mind

www.leosworkshop.com

User avatar
martin54
Vectric Wizard
Posts: 4790
Joined: Fri Nov 09, 2012 2:12 pm
Model of CNC Machine: Gerber System 48 (modified)
Location: Crossgates, Scotland

Re: Defining tapered endmills

Post by martin54 »

Well I've once again learnt something new, I didn't know the tapered endmill option was available in the tool data base, mind you I don't have any tapered endmills at the moment so I have a small excuse :lol: :lol: :lol:

Post Reply