Elephant night light measures 3.5" by 3' high. Took 2 hrs to cut using .125 ball nose for rough and .0625 ball nose for finish cut.
Tony
elephant night light
-
- Vectric Wizard
- Posts: 772
- Joined: Sat Jan 09, 2010 7:28 am
- Model of CNC Machine: cnc mako shark ext bed with HD 5 gantry
- Location: Buffalo,NY
-
- Vectric Wizard
- Posts: 414
- Joined: Wed Apr 01, 2009 12:15 am
- Location: Dunnellon, Florida
Re: elephant night light
Hi: Great job. Might I offer a tip? If you use a 1/4 inch shank tapered .0625 4 flute ball nose from Bits n Bits you can eliminate the rough cut and directly do the finish cut. Those bits are very strong and last a long time. Plus being 4 flutes you can reduce the router rpm's almost by half and loose a lot of noise. Norm
Re: elephant night light
Do you have a link for Bits n Bits? I googled Bits n Bits and couldn't find what you mentioned.
Thanks,
Phil
Thanks,
Phil
-
- Vectric Wizard
- Posts: 772
- Joined: Sat Jan 09, 2010 7:28 am
- Model of CNC Machine: cnc mako shark ext bed with HD 5 gantry
- Location: Buffalo,NY
Re: elephant night light
Phil,
Heres the website for bits n bits http://bitsbits.com/
Norm,
Also, thanks for the tip for the tapered ballnose bit.
Tony
Heres the website for bits n bits http://bitsbits.com/
Norm,
Also, thanks for the tip for the tapered ballnose bit.
Tony
- mikeacg
- Vectric Wizard
- Posts: 659
- Joined: Sun Nov 02, 2008 10:53 pm
- Model of CNC Machine: Camaster Stinger, Sidewinder, SB 4x4
- Location: Newberry, MI
- Contact:
Re: elephant night light
Norm,
Do you have a part number for the 1/4 inch shank tapered .0625 4 flute ball nose? I can't find it on the website. I found a 2 flute but not a 4...
Thanks,
Mike
Do you have a part number for the 1/4 inch shank tapered .0625 4 flute ball nose? I can't find it on the website. I found a 2 flute but not a 4...
Thanks,
Mike