AXYZ Toolpath problems
AXYZ Toolpath problems
Hi everyone, anybody using a AXYZ Machine with Toolpath. I cannot get the tool path software to accept Aspire files, keep getting "critical error, program terminated". AXYZ want a $12,000 ransom to get my machine software working/repaired. Please help..........
- Adrian
- Vectric Archimage
- Posts: 14546
- Joined: Thu Nov 23, 2006 2:19 pm
- Model of CNC Machine: ShopBot PRS Alpha 96x48
- Location: Surrey, UK
Re: AXYZ Toolpath problems
Which post processor are you using in Aspire to create the files that you are loading into the toolpath software?
-
- Vectric Wizard
- Posts: 678
- Joined: Thu Jan 15, 2009 1:08 am
- Model of CNC Machine: AXYZ 5010
- Location: Maryhill Ontario Canada
- Contact:
Re: AXYZ Toolpath problems
I'm running an AXYZ 5010 with a tool changer.
Once the post was sorted out, I've never had any issues with Aspire.
If The guys at Vectric give the Ok, I'd be happy to send it to you.
john
Once the post was sorted out, I've never had any issues with Aspire.
If The guys at Vectric give the Ok, I'd be happy to send it to you.
john
- Mark
- Vectric Staff
- Posts: 1054
- Joined: Sat Aug 18, 2007 2:55 pm
- Model of CNC Machine: CNC Shark, ShopBot, Roland PNC3000
- Location: Alcester U.K.
- Contact:
Re: AXYZ Toolpath problems
Hello guamcnc,
I am not sure that the problem that you are describing is a post processor problem.
If the control software on your machine is not working, you will need to address this
problem first.
If there is anything that you think that we might be able to help with, please drop us an
email to support.
I hope that this helps,
Cheers.
Mark.
I am not sure that the problem that you are describing is a post processor problem.
If the control software on your machine is not working, you will need to address this
problem first.
If there is anything that you think that we might be able to help with, please drop us an
email to support.
I hope that this helps,
Cheers.
Mark.
- rscrawford
- Vectric Wizard
- Posts: 1102
- Joined: Mon Jan 17, 2011 6:49 pm
- Model of CNC Machine: CAMaster Cobra 408 ATC, ShopSabre IS408
- Location: Wetaskiwin, Alberta
- Contact:
Re: AXYZ Toolpath problems
Geez, for $12,000 you could get a whole new control system for your CNC, complete with WinCNC and a mother/daughter board, control board, new servo motors and drivers, a new computer, etc. . . And all that would probably be less than half their repair cost. . .
Russell Crawford
http://www.cherryleaf-rustle.com
http://www.cherryleaf-rustle.com