Hi Todd,
Are you guys looking at providing “laser ready” files like 3DWave, I have purchased a number of these image files over the last month.
Thanks
Ron
Laser files
Moderator: Todd Bailey
- Aussie
- Vectric Wizard
- Posts: 566
- Joined: Fri Nov 30, 2018 1:44 am
- Model of CNC Machine: Robotics Model 8
- Location: Adelaide Australia
Laser files
Ron
Crafers Crafts
Crafers Crafts
- Todd Bailey
- Vectric Staff
- Posts: 625
- Joined: Mon Nov 24, 2014 8:40 pm
- Model of CNC Machine: CraftCNC
- Contact:
Re: Laser files
Hello Ron...
Thanks for the question. At this point no, creating a good "laser ready" file is a bit different than creating "CNC ready" bas-relief files. It is not just as simple as creating a grayscale image from a 3D model.
Thanks for asking...
Thanks for the question. At this point no, creating a good "laser ready" file is a bit different than creating "CNC ready" bas-relief files. It is not just as simple as creating a grayscale image from a 3D model.
Thanks for asking...
------------------------------------
Todd Bailey | Design and Make
DesignAndMake.com
Todd Bailey | Design and Make
DesignAndMake.com