Post
-
- Posts: 3
- Joined: Wed Dec 16, 2015 12:49 am
- Model of CNC Machine: laguna
- Location: Morganton, NC
Post
I have a Laguna IQ and when I go to save to my PP it does not have one for the Laguna. How can I fix this?
- mtylerfl
- Vectric Archimage
- Posts: 5896
- Joined: Thu Jan 29, 2009 3:54 am
- Model of CNC Machine: -CarveWright CNC -ShopBot Buddy PRSAlpha
- Location: Brunswick, GA
Re: Post
Hi Joey,
There might be someone here that can help (I hope so), but have you checked in with Laguna Tech Support on this?
There might be someone here that can help (I hope so), but have you checked in with Laguna Tech Support on this?
Michael Tyler
facebook.com/carvebuddy
-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC
facebook.com/carvebuddy
-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC
-
- Posts: 3
- Joined: Wed Dec 16, 2015 12:49 am
- Model of CNC Machine: laguna
- Location: Morganton, NC
Re: Post Processor
When I go to save to my Post Processor their is not one for Laguna
- highpockets
- Vectric Wizard
- Posts: 3667
- Joined: Tue Jan 06, 2015 4:04 pm
- Model of CNC Machine: PDJ Pilot Pro
Re: Post
I don't have PhotoVCarve so I hope I'm not steering you wrong...
Open up PhotoVCarve on the File menu option select Open Application Data Folder. Open the folder PostP and look for Laguna_IQ_xxxx. I have a couple of Laguna_IQ pp options, I can't tell you which one you should use.
Hope this helps.
If the Laguna pp files are not there then I'm with Michael, contact Laguna Tech Support.
Open up PhotoVCarve on the File menu option select Open Application Data Folder. Open the folder PostP and look for Laguna_IQ_xxxx. I have a couple of Laguna_IQ pp options, I can't tell you which one you should use.
Hope this helps.
If the Laguna pp files are not there then I'm with Michael, contact Laguna Tech Support.
John
Maker of Chips
Maker of Chips
- Adrian
- Vectric Archimage
- Posts: 14683
- Joined: Thu Nov 23, 2006 2:19 pm
- Model of CNC Machine: ShopBot PRS Alpha 96x48
- Location: Surrey, UK
Re: Post
PhotoVCarve doesn't have the Open Application Data folder option. The posts are stored within the PostP folder in the Program Files folder where the program is installed.
- highpockets
- Vectric Wizard
- Posts: 3667
- Joined: Tue Jan 06, 2015 4:04 pm
- Model of CNC Machine: PDJ Pilot Pro
- scotttarnor
- Vectric Wizard
- Posts: 945
- Joined: Fri Aug 30, 2019 11:40 pm
- Model of CNC Machine: Piranha XL , Shark HD520
- Location: La Crosse WI
Re: Post
I have never used Photo Vcarve to create the tap file because there were none available for the Piranha either, I always save the file as a .pvc and open it in Vcarve, it is an extra step but I feel it is worth it because Vcarve gives a better preview than Photo carve IMO.
Scott T
@scottscnc
@scottscnc