This forum is for general discussion about PhotoVCarve.
2 posts • Page 1 of 1
Got into my first project and realized I don’t have many bits since I just got a starter set with my CNC. My best result was with a 30* 0.25 vbit but I feel like I should be able to get better definition. What are some of your favorite bits to use with PVC before I run off to Amazon and fill my cart with useless bits?
- Vectric Wizard
- Posts: 386
- Joined: Wed Apr 01, 2009 12:15 am
- Location: Dunnellon, Florida
Hi: For lithophanes I use a tapered .0625 ball nose on pictures that don't have too much intricate detail. For highly detailed pictures I have gone down as small as .020 ball nose. The smaller the bit, the more time it takes.