EMC2
-
PeteC
- Vectric Apprentice
- Posts: 68
- Joined: Wed Oct 05, 2011 1:59 pm
- Model of CNC Machine: Probotix FireBall Comet
- Location: North East Kingdom of Vermont
EMC2
Hello all, I'm trying to make my first Lithophane from PhotoVcarve and I'm running a Ubuntu with EMC2 PP. I tried run GCode_inch.pp but Ubuntu will not show the toolpath. Is there a way to add EMC2 too Photocarve ? Thank you.
Bigfoot
-
CharlieP
- Vectric Staff
- Posts: 166
- Joined: Wed Jun 04, 2014 10:25 am
- Model of CNC Machine: Saimsmart CNC
Re: EMC2
Hello Pete,
If you would like to contact Support@vectric.com we can see if we can help on this.
Best Regards
If you would like to contact Support@vectric.com we can see if we can help on this.
Best Regards