VCarve Pro Missing Modeling tab

[Jyuma]

There is supposed to be a modeling tab on the bottom left next to or under Drawings, but it's not there and I can't find it anywhere.

The manual says the tab is normally found on the bottom left after Drawings, but no mention of where it is found abnormally.

Suggestions?

Thanks
Ed

[Rcnewcomb]

What version are you running?
In V11.5 there was a modeling tab.
In V12 the modeling tools were moved to the Design tab

[sharkcutup]

The Modeling Tab has been Renamed Components in Version 12.0 and Up See attached ---

And some of its features have been added to the Design Tab for convenience as noted in a previous post.

Sharkcutup

[Jyuma]

Thank you both for your thoughtful replies.

I am using VCarve Pro Version 12.

It took a lot of searching but I eventually found the modeling buttons.

Thanks again.