I am totally new at this. Purchased OneFinity Woodworker with J-Tech laser. Have VcarvePro w/laser module and post processor. I download the file, start up the laser and push the play button - the laser fires as the spindle starts to move drawing a line to the place where I actually want it to start the pattern. It has happened several times. What am/have I done wrong?
Piddlin'
Laser Firing Before at Start of Pattern
- scotttarnor
- Vectric Wizard
- Posts: 945
- Joined: Fri Aug 30, 2019 11:40 pm
- Model of CNC Machine: Piranha XL , Shark HD520
- Location: La Crosse WI
Re: Laser Firing Before at Start of Pattern
Sounds like you have the incorrect Post processor. I would check the manufacturers and Jtechs website or forums for others who may have had the same issue.
Onefinity is not on the list of supported manufacturers
Onefinity is not on the list of supported manufacturers
Scott T
@scottscnc
@scottscnc
- gkas
- Vectric Wizard
- Posts: 1451
- Joined: Sun Jan 01, 2017 3:39 am
- Model of CNC Machine: Aspire, Axiom AR8 Pro+, Axiom 4.2W Laser
- Location: Southern California
Re: Laser Firing Before at Start of Pattern
The AXIOM CNC have this same problem. They change the SPINDLE DELAY from 4 seconds to 0.
-
- Posts: 4
- Joined: Tue Jun 29, 2021 3:20 pm
- Model of CNC Machine: onefinity woodworker
- Location: Styx, TX
Re: Laser Firing Before at Start of Pattern
Thank you each for the messages and guidance. They are helpful. I'm still trying to figure out this forum business. BTW the JTEC laser is the one sold as 1F laser system. I downloaded the inches post processor from the Jtech web site, however, I am going to do it again and reinstall. I have run a couple of designs without problem and then a couple with the early firing so I'm at a loss. Thank you once again. Have a great Independence Day and fun CNCing.
David
David