I have gotten a response from both Vectric and Next Wave Automation.
Mr. Mark Moran from Vectric Ltd. indicated they may have resolved the hatching problems. To correct this problem they have had to come up with a new laser hatching strategy. However, this fix will not be released until the release of V11 later in the year.
My response from Next Wave Automation was they are working on the issues with laser photos. They are close to resolving this issue, but do not have any timeline as to when it may be corrected. They have sent some beta versions of the control software to Vectric and they have tested those. It appears most of the issues there have also been worked out.
All we can do now is wait.