Box Creator Mods

This forum has been created for users to submit suggestions for Gadgets
Post Reply
leversole
Posts: 19
Joined: Sun Feb 07, 2016 7:03 pm
Model of CNC Machine: OX Type

Box Creator Mods

Post by leversole »

Would like a small change in the box creator, may be simple...I have looked through the code and cannot find the right spot...

What I would like is to suppress the small "tails" where the router bit sets clearance for the sharp corners of the dovetails...I use a very small bit and through testing, I do not need these...I have been going through and node editing the tool paths to get rid of these, very time consuming!

I am hoping that these are done with a fucntion call that I can supress, or a series of lines in a function I can rem out...If someone can point me the section of code that creates these I would be most appreciative

Thanks
Leslie

leversole
Posts: 19
Joined: Sun Feb 07, 2016 7:03 pm
Model of CNC Machine: OX Type

Re: Box Creator Mods

Post by leversole »

Maybe not the correct way...but it worked...
Hack.jpg

User avatar
jimandi5000
Vectric Wizard
Posts: 1050
Joined: Wed Mar 11, 2015 6:50 pm
Model of CNC Machine: Home Made 60 x 120
Location: North Houston Tx.
Contact:

Re: Box Creator Mods

Post by jimandi5000 »

Would like it turned off or as an optional setting or based on a bit size?
Thanks,
Jim

leversole
Posts: 19
Joined: Sun Feb 07, 2016 7:03 pm
Model of CNC Machine: OX Type

Re: Box Creator Mods

Post by leversole »

Probably optional is better than based on bit size...

Thanks

User avatar
jimandi5000
Vectric Wizard
Posts: 1050
Joined: Wed Mar 11, 2015 6:50 pm
Model of CNC Machine: Home Made 60 x 120
Location: North Houston Tx.
Contact:

Re: Box Creator Mods

Post by jimandi5000 »

leversole wrote:Probably optional is better than based on bit size...

Thanks

I will have a look and see if I can add that option. :)
Thanks,
Jim

Post Reply