Would like a small change in the box creator, may be simple...I have looked through the code and cannot find the right spot...
What I would like is to suppress the small "tails" where the router bit sets clearance for the sharp corners of the dovetails...I use a very small bit and through testing, I do not need these...I have been going through and node editing the tool paths to get rid of these, very time consuming!
I am hoping that these are done with a fucntion call that I can supress, or a series of lines in a function I can rem out...If someone can point me the section of code that creates these I would be most appreciative
Thanks
Leslie
Box Creator Mods
Re: Box Creator Mods
Maybe not the correct way...but it worked...
- jimandi5000
- Vectric Wizard
- Posts: 1056
- Joined: Wed Mar 11, 2015 6:50 pm
- Model of CNC Machine: Home Made 60 x 120
- Location: North Houston Tx.
- Contact:
Re: Box Creator Mods
Would like it turned off or as an optional setting or based on a bit size?
Thanks,
Jim
Jim
Re: Box Creator Mods
Probably optional is better than based on bit size...
Thanks
Thanks
- jimandi5000
- Vectric Wizard
- Posts: 1056
- Joined: Wed Mar 11, 2015 6:50 pm
- Model of CNC Machine: Home Made 60 x 120
- Location: North Houston Tx.
- Contact:
Re: Box Creator Mods
leversole wrote:Probably optional is better than based on bit size...
Thanks
I will have a look and see if I can add that option.
Thanks,
Jim
Jim