Easy Tray Maker Gadget

[sharkcutup]

Is there an easy tray for 9.5 ?

I would be confident in saying: no. The version 1.0 posted at the start of this thread will only work in version 10 or above (Aspire / VCarve) so no other later version of the gadget would work in v9.5.

It would be possible (perhaps) to alter the program so that it will work in all versions from Aspire 4 and VCarve 8 to v12 for both. I have done that in my own gadgets and for some of Paul Rowntree's ones.

The only thing that would make it difficult is if Jim used commands related to sheets.

I do not believe in the latest version there is anything related to sheets. I will look over the code to be sure.

Sharkcutup

[sharkcutup]

The Latest Version does have the CutBySheets command in the code. So Yeah the code would have to be modified to be used for the earlier Vectric Software Versions.

Sharkcutup