Dave
Live edge carving
-
woody53
- Vectric Wizard
- Posts: 493
- Joined: Sat Jun 11, 2011 3:27 pm
- Model of CNC Machine: Probotix Meteor 25 x 50
- Location: Jefferson City, Mo.
Live edge carving
Did this yesterday. Took 6 hours 1/4 em roughing 1/8 ball nose finishing. Got a coat of finish on it today (still wet), other pic is just off machine. Has a crack in the back epoxied it and sanded out, a little bit shows in the front, but is fine.
Dave
Dave
-
Bob Reda
- Vectric Wizard
- Posts: 858
- Joined: Wed Aug 16, 2006 7:34 pm
- Model of CNC Machine: shopbot 48x48 upgraded prt
- Location: Monessen, Pa
- Contact:
Re: Live edge carving
very nice, walnut is a nice wood to carve
Bob
Bob
-
Sled
- Posts: 14
- Joined: Thu Jan 19, 2023 2:25 pm
- Model of CNC Machine: 4’x4’ bed - 24,000 RPM - homemade
Re: Live edge carving
I enjoy live edge. Nice carve! I have a lot of live edge mesquite that I’m worried about my feeds and speeds. It’s such a hard wood.
-
SteveNelson46
- Vectric Wizard
- Posts: 2304
- Joined: Wed Jan 04, 2012 2:43 pm
- Model of CNC Machine: Camaster Stinger 1
- Location: Tucson, Az.
Re: Live edge carving
That looks pretty good. Do you plan to use it in a project or just as decorative art work?
Steve
-
woody53
- Vectric Wizard
- Posts: 493
- Joined: Sat Jun 11, 2011 3:27 pm
- Model of CNC Machine: Probotix Meteor 25 x 50
- Location: Jefferson City, Mo.
Re: Live edge carving
Just wanted to get machine warmed up and running. Been neglecting it for a few months. Running just like new!!
Dave
Dave
-
Luvtocarve
- Vectric Craftsman
- Posts: 200
- Joined: Sat May 16, 2020 4:32 pm
- Model of CNC Machine: Next Wave Piranha XL
- Location: Wadsworth, Ohio
- Contact:
Re: Live edge carving
Very nicely done. Beautiful piece of walnut and great finish.
Steve Harp
Wadsworth, Ohio USA
www.trlw.us
Wadsworth, Ohio USA
www.trlw.us