had a project that fitted perfectly to try out the new vectric software. it came out flawlessly:)
Mankala is a easy to learn but hard to master boardgame.
tested out v11 on this Mankala board
-
- Posts: 6
- Joined: Tue May 07, 2019 4:29 pm
- Model of CNC Machine: Workbee
- scotttarnor
- Vectric Wizard
- Posts: 945
- Joined: Fri Aug 30, 2019 11:40 pm
- Model of CNC Machine: Piranha XL , Shark HD520
- Location: La Crosse WI
- Todd Bailey
- Vectric Staff
- Posts: 625
- Joined: Mon Nov 24, 2014 8:40 pm
- Model of CNC Machine: CraftCNC
- Contact:
Re: tested out v11 on this Mankala board
Hello Sveininge79!
Super job using dish components for this... really thinking outside of the box! My kind of project!!!
Thanks for sharing!!!
Super job using dish components for this... really thinking outside of the box! My kind of project!!!
Thanks for sharing!!!
------------------------------------
Todd Bailey | Design and Make
DesignAndMake.com
Todd Bailey | Design and Make
DesignAndMake.com
-
- Posts: 6
- Joined: Tue May 07, 2019 4:29 pm
- Model of CNC Machine: Workbee
Re: tested out v11 on this Mankala board
Pretty easy project to
setup in vcarve just used the dish and offsets the outline:) used a 4mm ballnose on the bowls and texture, 3 mill straight mill for the cutout and a vbit for the text.
setup in vcarve just used the dish and offsets the outline:) used a 4mm ballnose on the bowls and texture, 3 mill straight mill for the cutout and a vbit for the text.