Page 1 of 1

Totoro

Posted: Sun Oct 04, 2020 12:39 pm
by JoeBlow
Totoro in Cherry.

Frame and panel cut as separate jobs. Both were 2 sided as the frame has a panel rabbit cut in back and the panel was engraved with an inscription on the back for my daughter who recently turned 20. We watched all the Studio Ghibli movies together as she grew up.

Panel is a 30* dome with the V carving projected to the 3D model. Frame was cut using the moulding toolpath.

Began as a bitmap and then traced and edited. That part of the process is so time consuming but rather relaxing and I like the results.

Totoro.JPG

Here is the file saved in Vcarve format for the Totoro fans out there.

Totoro.crv
(403.5 KiB) Downloaded 55 times

Re: Totoro

Posted: Sun Oct 04, 2020 1:52 pm
by Phil
Really nice project. As Siskel and Ebert used to say in a review; "Two thumbs up." :)

Phil

Re: Totoro

Posted: Sun Oct 04, 2020 3:49 pm
by Fleming
Beautiful work!!! I love the way cherry carves - I wish I had some large pieces of it!

Re: Totoro

Posted: Sun Oct 04, 2020 4:56 pm
by Savannahdan
It's funny that the preview doesn't do justice to it like yours in cherry and the frame. Nice and clean. Thank you.

Re: Totoro

Posted: Mon Oct 05, 2020 2:16 am
by scottp55
Nice clean cut and arrangement Joe!
Pleasing combo to the eye(except for the critters themselves :) :) )
Well Done.
scott

Re: Totoro

Posted: Tue Oct 06, 2020 10:44 am
by JoeBlow
Thank you for the kind comments. First time with cherry on the cnc and I was very pleased with how well it carved and held the small details.

Re: Totoro

Posted: Tue Oct 06, 2020 7:16 pm
by adze_cnc
Poor "rabbits"...always being cut and butchered by woodworkers.

Re: Totoro

Posted: Thu Oct 08, 2020 8:23 pm
by woody53
Very nice piece of work. I Love to carve cherry, it holds very good detail for me. Great job.

Dave