“Some Gave All”
-
- Vectric Craftsman
- Posts: 200
- Joined: Sat May 16, 2020 4:32 pm
- Model of CNC Machine: Next Wave Piranha XL
- Location: Wadsworth, Ohio
- Contact:
“Some Gave All”
This was done on Next Wave Piranha XL. Carve time about 3 hours.
Steve Harp
Wadsworth, Ohio USA
www.trlw.us
Wadsworth, Ohio USA
www.trlw.us
- CrowsWW
- Vectric Craftsman
- Posts: 155
- Joined: Wed Jun 27, 2012 7:10 pm
- Model of CNC Machine: ShopSabre 4896
- Location: Palmer, Alaska USA
Re: “Some Gave All”
Luvtocarve,
That is very awesome. I am sure the veterans that will see this will appreciate it.
Thanks for Sharing
That is very awesome. I am sure the veterans that will see this will appreciate it.
Thanks for Sharing
Troy Crow
Crow's Woodwork's
I have a day job to support my wood habit!
Crow's Woodwork's
I have a day job to support my wood habit!
-
- Vectric Craftsman
- Posts: 216
- Joined: Sat Feb 03, 2018 2:03 am
- Model of CNC Machine: diy 4 X 4 CNC Router
- Location: So. Cal.
Re: “Some Gave All”
Nice, like it.
Good job.
mark-s
Good job.
mark-s
- scotttarnor
- Vectric Wizard
- Posts: 944
- Joined: Fri Aug 30, 2019 11:40 pm
- Model of CNC Machine: Piranha XL , Shark HD520
- Location: La Crosse WI