Customer Ricky Bennett (SCANCAD) is using VCW to engrave Brass Plaques and Stone Memorials on a Newing Hall Pantocut 4E with a Beyerholm & Moe Microstep controller.
This project has been engraved using a combination of 2D Pocket machining for the large text and 3D Engraving for the smaller text
Paint (Coach Enamel) is injected into the engraving to give a deep gloss and 'craftsman made' look to the plaque.
The picture shows the plaque before it's been cleaned and polished.
Tony
Engraved Brass Plaque
Engraved Brass Plaque
- Attachments
-
- SAMPLE-BRASS-NAMEPLATE.gif
- (139.04 KiB) Downloaded 404 times
- dighsx
- Vectric Wizard
- Posts: 939
- Joined: Tue Nov 01, 2005 12:36 am
- Location: Royal Oak, Michigan USA
- Contact:
Do you have more info on how they 'inject' the paint into the letters? That gives a cool effect.
Take it easy.
Jay (www.cncjay.com)
Jay (www.cncjay.com)