This is my first top using a D&M dish... lots to learn.
First attachment as well...hope I did it correctly
Keepsake Box
- Aussie
- Vectric Wizard
- Posts: 564
- Joined: Fri Nov 30, 2018 1:44 am
- Model of CNC Machine: Robotics Model 8
- Location: Adelaide Australia
Re: Keepsake Box
ok I did something wrong...why are my attached images inverted???
Ron
Crafers Crafts
Crafers Crafts
-
- Vectric Craftsman
- Posts: 260
- Joined: Tue Mar 11, 2014 6:12 pm
- Model of CNC Machine: salecnc XJ1224
- Location: Auckland New Zealand
Re: Keepsake Box
There upside down because your from down under!.........same thing happened to me apple IPhone is it.
don't worry, nice box though. What it the wood that you used?.
regards
Brian
don't worry, nice box though. What it the wood that you used?.
regards
Brian
- Aussie
- Vectric Wizard
- Posts: 564
- Joined: Fri Nov 30, 2018 1:44 am
- Model of CNC Machine: Robotics Model 8
- Location: Adelaide Australia
Re: Keepsake Box
Haha very funny.... but we are from the future.MTSO wrote:There upside down because your from down under!.........same thing happened to me apple IPhone is it.
don't worry, nice box though. What it the wood that you used?.
regards
Brian
Top is Red Oak sides are Merbau Decking timber
Ron
Crafers Crafts
Crafers Crafts
- Aussie
- Vectric Wizard
- Posts: 564
- Joined: Fri Nov 30, 2018 1:44 am
- Model of CNC Machine: Robotics Model 8
- Location: Adelaide Australia
Re: Keepsake Box
Thank youWNC_Ed wrote:Very nice!
Truly a keepsake.
Congrats
The next box will all be done on the CNC except the mitred edges for the trim... not sure how I could do the 45 degree joints on narrow stock...1/4" by 1/4"
Ron
Crafers Crafts
Crafers Crafts