Vectric Customer

I saw this nifty cutting board made by Scott Lewis, and featured by Fine Woodworking, http://www.finewoodworking.com/how-to/v ... -ever.aspx
So I copied it as a birthday present for my wife. It is a nice combination of cnc and conventional woodworking.
It's one of those projects that looks kind of simple until you start looking at the variables, and procedures. Bob

I always liked those:)
GOOD Work

Very impressive. It's obvious it would take quite an effort to do manually, and I'm sure it wasn't trivial even with CNC!

Wow! That is really classy and nice!

Thanks,
It was fun watching Scott's video, then appreciating, and copying his technique. The cnc saved some time and added accuracy when cutting out the curvy profiles, but there was still a lot of gluing, then cutting into the finished work for the next band. And, making sure everything lined up properly while gluing.
Fun stuff.
Bob

...This seemed like a good picture to add. You can never have too many clamps:

Bob,

Very nice. Too nice to cut on!

Roy