A finished product

An area to upload images of pieces cut using VCarve Pro
Post Reply
Samson
Vectric Wizard
Posts: 323
Joined: Fri May 02, 2014 10:14 pm
Model of CNC Machine: 4x4

A finished product

Post by Samson »

This is most likely my last post on here, so I figured I would show a finished piece to say farewell.







Image

I bid you adieu...

Gerry Perrault
Vectric Apprentice
Posts: 73
Joined: Thu Mar 13, 2008 11:04 pm
Location: Granby,Qc, Canada
Contact:

Re: A finished product

Post by Gerry Perrault »

Is there a reason why you are saying this is your last post, without being too personal.
a) you are sick
B) you don't like the forum
c) you are quiting your job
d) any other reason

it is too bad, did a very nice finish on that symbol, by the way wath is it
Gerry
I rather be the leader,than the follower

Post Reply