A little project for work, cutting a foam insert to take a radio mic/in-ear monitor kit to fit into a briefcase.
Cutting a foam insert for a radio mic kit
- scotttarnor
- Vectric Wizard
- Posts: 941
- Joined: Fri Aug 30, 2019 11:40 pm
- Model of CNC Machine: Piranha XL , Shark HD520
- Location: La Crosse WI
- Aussie
- Vectric Wizard
- Posts: 564
- Joined: Fri Nov 30, 2018 1:44 am
- Model of CNC Machine: Robotics Model 8
- Location: Adelaide Australia
Re: Cutting a foam insert for a radio mic kit
Very nice
Can you tell me the bit you used
Thanks
Ron
Ron
Crafers Crafts
Crafers Crafts
-
- Vectric Wizard
- Posts: 409
- Joined: Thu Apr 06, 2017 3:07 am
- Model of CNC Machine: Camaster Stinger SR24
- Location: Addison, PA
Re: Cutting a foam insert for a radio mic kit
Nicely done! I would love to hear more about the material used, bits, feeds/speeds, etc, if you care to share the details.
I can see some workshop drawer organizers coming from this.
I can see some workshop drawer organizers coming from this.
Joe
I have a chip on my shoulder....several more in my hair and lots more all over my shop floor.
I have a chip on my shoulder....several more in my hair and lots more all over my shop floor.
Re: Cutting a foam insert for a radio mic kit
Holzarbeiter wrote: ↑Sat Feb 29, 2020 3:21 pmNicely done! I would love to hear more about the material used, bits, feeds/speeds, etc, if you care to share the details.
I can see some workshop drawer organizers coming from this.
Me too.
Phil
Re: Cutting a foam insert for a radio mic kit
Thanks for the positive comments.
Bit used: 20mm clearance, 6.3mm final cut.
Check out
Cheers Peter
Bit used: 20mm clearance, 6.3mm final cut.
Check out
Cheers Peter
Re: Cutting a foam insert for a radio mic kit
What kind of foam did you use ? any special kind or just plain regular ole' foam..........
-
- Posts: 1
- Joined: Mon Aug 08, 2022 12:44 pm
- Model of CNC Machine: Workbee Z1
Re: Cutting a foam insert for a radio mic kit
I've heard EVA foam is good to use for this type of thing? What Bit are we talking about? Wasn't quite sure.