Dovetail gadget for vertical holding

[woodskills]

HI,

I have not used any of the dovetail gadgets but the first one I looked at was for cutting dovetails flat on the table which creates some issues due to bit diameters. Since I built a vertical holding area for my table is there a specific dovetail gadget that supports regular dovetail bits. Normally, I will do a clearing pass with a downcut bit to lessen the strain on the dovetail bit. I have laid them out in VCarve manually but a gadget could do it in more efficient manner. Any recommendations would be appreciated.

John

[sharkcutup]

Jimandigadgets

Easy Dovetail Maker Gadget

Sharkcutup

[adze_cnc]

 
I think you forgot to post a link to where the original poster might find it: EasyDovetail Gadget

[jimandi5000]

HI,

I have not used any of the dovetail gadgets but the first one I looked at was for cutting dovetails flat on the table which creates some issues due to bit diameters. Since I built a vertical holding area for my table is there a specific dovetail gadget that supports regular dovetail bits. Normally, I will do a clearing pass with a downcut bit to lessen the strain on the dovetail bit. I have laid them out in VCarve manually but a gadget could do it in more efficient manner. Any recommendations would be appreciated.

John

Hi John, I am posting the new version in a day or so. EasyDovetailMaker version 6.1

[sharkcutup]

 
I think you forgot to post a link to where the original poster might find it: EasyDovetail Gadget

Thank You adze_cnc

Sharkcutup