How to fix drag knive overcut

This section is for general discussion about Gadgets
Post Reply
Posts: 3
Joined: Fri Feb 04, 2022 1:37 pm
Model of CNC Machine: Avid cnc

How to fix drag knive overcut

Post by ROTM »

Good day.
I have just finished cutting with the Donex drag knive d2 a thin piece of cardboard 0.016"
There are some areas where it cuts a bit too much and some where it doesn't cut to the end.
I am guessing the problem it is my settings ...but how can I fix these?
Attached a pic of the dragknife settings and one of the issue.(I'm using vcarve pro)

Any help would be appreciated.

Thank you!
dknife setup.png

Post Reply