Hi All,
Trying the box gadget. The generated box layout is always located outside of the stock size I define. Regardless if I make the stock size way larger than needed. Can't figure out what I'm doing wrong.
Thanks in advance !
Brian
Box Gadget and stock alignment
-
- Posts: 20
- Joined: Mon Jun 28, 2010 2:01 am
- Model of CNC Machine: Tormach PCNC II/III
- Location: Ohio
- adze_cnc
- Vectric Wizard
- Posts: 4324
- Joined: Sat Jul 27, 2013 10:08 pm
- Model of CNC Machine: AXYZ 4008
- Location: Vancouver, BC, Canada
Re: Box Gadget and stock alignment
This 3 and a 1/2 minute video might help: https://www.youtube.com/watch?v=-rPxi5QTD2E
-
- Vectric Craftsman
- Posts: 182
- Joined: Sat Jun 30, 2012 1:41 am
- Model of CNC Machine: CAMaster Stinger II
- Location: Wisconsin
Re: Box Gadget and stock alignment
Maybe try material zero in lower left corner?
Charlie
Aspire, CAMaster Stinger II
Aspire, CAMaster Stinger II
Re: Box Gadget and stock alignment
New user here, I can setup my job just fine…but it just occurred to me, does this box gadget calculate the size of the inside of the box? Can this be set in the parameters. Thanks…