Box Gadget What I learned from it.

This section is for general discussion about Gadgets
Post Reply
Mark Jones
Posts: 10
Joined: Fri Aug 28, 2020 8:38 pm
Model of CNC Machine: Shark HD 5

Box Gadget What I learned from it.

Post by Mark Jones »

I have enjoyed using the Vcarve Pro and the Box Creator Gadget. This video shows what I learned from it this past week. Some of these tips may benefit you and if you have a tip that will help me please say so. After cutting up three sheets of 1/4" 4x8 plywood I learned a few things from it. Using the Tile Toolpath to handle the output of the gadget is key to making boxes that fit every time.



Mark Jones

bravesoul1950
Posts: 25
Joined: Thu Apr 30, 2015 8:23 pm
Model of CNC Machine: Shopbot

Re: Box Gadget What I learned from it.

Post by bravesoul1950 »

Thank you Mark, very informative.

Joe

Todd D
Posts: 16
Joined: Fri Feb 07, 2020 4:07 am
Model of CNC Machine: Axiom AR8 PRO V5

Re: Box Gadget What I learned from it.

Post by Todd D »

thanks for that I'm going to try this out, have some drawers to make coming up

User avatar
scotttarnor
Vectric Craftsman
Posts: 271
Joined: Fri Aug 30, 2019 11:40 pm
Model of CNC Machine: Piranha XL , Shark HD520
Location: La Crosse WI

Re: Box Gadget What I learned from it.

Post by scotttarnor »

Thank you !
Scott T

User avatar
scotttarnor
Vectric Craftsman
Posts: 271
Joined: Fri Aug 30, 2019 11:40 pm
Model of CNC Machine: Piranha XL , Shark HD520
Location: La Crosse WI

Re: Box Gadget What I learned from it.

Post by scotttarnor »

I liked your advice on the USB port also so I picked up one of these on Amazon.
Attachments
image.jpg
Scott T

Post Reply