Box gadget Question

This section is for general discussion about Gadgets
Post Reply
newcarver
Vectric Apprentice
Posts: 14
Joined: Sun Mar 08, 2015 9:38 pm
Model of CNC Machine: Axiom

Box gadget Question

Post by newcarver »

I am new to Aspire and have been playing around with the box making gadget V9. I have a few newbie questions if anyone can help.
I sometimes get a box that just won't fit together meaning 1/8 too big or 1/16th too small. I usually run an 1/8 end mill with the tool path cutting on the line. I set the gap to .005. Do you have to run the tool path to cut on the line or outside of the line?
The gaps i am getting is about half the diameter of my 1/8" end mill.

My other question is if i want to make alot of boxes on a 4x4 plywood sheet can you copy and paste the first box or should you use array function?

I noticed when you try to move the box the original outline of the box always stays in the LH corner of my project. I like to move it over some so i can place a clamp there.

MMRHL
Posts: 3
Joined: Mon Dec 30, 2019 8:58 pm
Model of CNC Machine: Shapeoko XL

Re: Box gadget Question

Post by MMRHL »

This is when the allowance comes into play.

I'm trying to figure out how to make the box fit well together. At this time i can't figure out why the corners will not fit.

Post Reply