Chamfer gadget

This section is for general discussion about Gadgets
Post Reply
Vectric Apprentice
Posts: 4
Joined: Mon Jan 23, 2017 10:53 am
Model of CNC Machine: Stepcraft 420/1

Chamfer gadget

Post by CNCMiller »

Hello all,

If think a missed something.
I use Aspire v.9.0 and now I downloaded the chamfer gadget vesion 1.3 from the aspire v.9 site, however the gadget is still in version 1.2.
I am missing the checkbox for "chamfer towards line"(in or outside).

What do I wrong?
Where can I find version 1.3 of the chamfer gadget?

User avatar
Vectric Archimage
Posts: 10453
Joined: Thu Nov 23, 2006 2:19 pm
Model of CNC Machine: ShopBot PRS Alpha 96x48
Location: Surrey, UK

Re: Chamfer gadget

Post by Adrian »

You're not doing anything wrong. I'm guessing there was an error when the file was put on the website as it's 1.2 with some development code in it rather than 1.3 as far as I can tell.

Post Reply