Good day.
I have just finished cutting with the Donex drag knive d2 a thin piece of cardboard 0.016"
There are some areas where it cuts a bit too much and some where it doesn't cut to the end.
I am guessing the problem it is my settings ...but how can I fix these?
Attached a pic of the dragknife settings and one of the issue.(I'm using vcarve pro)
Any help would be appreciated.
Thank you!
How to fix drag knive overcut
- Mark Jones
- Vectric Craftsman
- Posts: 144
- Joined: Fri Aug 28, 2020 8:38 pm
- Model of CNC Machine: Shark HD 5
- Location: Ozark
- Contact:
Re: How to fix drag knive overcut
I am about to get one of these type tools. What I have read is the tool offset setting is what you need to adjust.
Mark Jones