Well,
I am using EasyCabinetMakerVer11.4 to make a cabinet. I can't seem to get the text where I can read it. Also it would be nice if it fit the job size and use layers.
Attached are snips of the issues.
Thanks again,
Willy
I am looking for something to do
- jimandi5000
- Vectric Wizard
- Posts: 1054
- Joined: Wed Mar 11, 2015 6:50 pm
- Model of CNC Machine: Home Made 60 x 120
- Location: North Houston Tx.
- Contact:
Re: I am looking for something to do
Hi Willy,
Thanks for letting me know about this issue. I will have a look at it in the morning and I will post an update ASP.
Thanks,
Jim
Jim
-
- Vectric Apprentice
- Posts: 53
- Joined: Mon Jul 19, 2021 9:14 pm
- Model of CNC Machine: AvidCNC
Re: I am looking for something to do
I have a question for you. How would I design the gears to run on the inside of a ring. Looks like the gear gadget only works for gears on the outside. The question is similar to the latest free monthly projects of Spiro Drawing board.
- adze_cnc
- Vectric Wizard
- Posts: 4367
- Joined: Sat Jul 27, 2013 10:08 pm
- Model of CNC Machine: AXYZ 4008
- Location: Vancouver, BC, Canada
Re: I am looking for something to do
For gears you might check FixitMike's article: viewtopic.php?t=21084
As well his posts earlier in this thread: viewtopic.php?p=278169#p278169
As well his posts earlier in this thread: viewtopic.php?p=278169#p278169
-
- Vectric Apprentice
- Posts: 53
- Joined: Mon Jul 19, 2021 9:14 pm
- Model of CNC Machine: AvidCNC
Re: I am looking for something to do
Thank you. much appreciated.