Carving a Angle on a Flat surface.

[pviljoen]

I have to carve an angle at the bottom part of an armrest, so that the arm rest fits snug to the back leg.
I have tried various methods including Moulding and chamfer paths. The system does no seem to extend the angle carve from end to end. It is either on the bottom of the carve or at the top and not the full thickness of the armrest.


Any Ideas?
I have added the Vcarve file. It is the small block at the left of the armrest, and is the underside of the armrest.

[pviljoen]

PS. The angle should be 45% from Right to left. The left line is equal to the top flat area of the arm rest. ie you are working on the underside of the armrest.

[sharkcutup]

I have to carve an angle at the bottom part of an armrest, so that the arm rest fits snug to the back leg.
I have tried various methods including Moulding and chamfer paths. The system does no seem to extend the angle carve from end to end. It is either on the bottom of the carve or at the top and not the full thickness of the armrest.


Any Ideas?
I have added the Vcarve file. It is the small block at the left of the armrest, and is the underside of the armrest.

Not many forum members make it here to the GADGET RELEASES

You need to post this in another location on the forum so it can be seen by more of the forum members

Sharkcutup