Rustic Welcome Door Plaque

Post Reply
David Corrigan
Vectric Craftsman
Posts: 218
Joined: Fri Jul 11, 2014 3:45 pm
Model of CNC Machine: ShopBot Desktop

Rustic Welcome Door Plaque

Post by David Corrigan »

I was reading through the Project Tutorial for the new monthly project, Rustic Welcome Door Plaque, and the CNC Bits used for the Sample include an Up-Cut End Mill. I can't find where that is used in the project. Can someone advise?

User avatar
scottp55
Vectric Wizard
Posts: 3436
Joined: Thu May 09, 2013 11:30 am
Model of CNC Machine: ShopbotDesktop 5.5"Z/spindle/VCP10
Location: Kennebunkport, Maine, US

Re: Rustic Welcome Door Plaque

Post by scottp55 »

Flat area clearance tool for the "Welcome"
"One accurate measurement is worth a thousand expert opinions"

GMH


scott

David Corrigan
Vectric Craftsman
Posts: 218
Joined: Fri Jul 11, 2014 3:45 pm
Model of CNC Machine: ShopBot Desktop

Re: Rustic Welcome Door Plaque

Post by David Corrigan »

Oh yes.... don't know how I missed that. Thank you.

User avatar
mtylerfl
Vectric Wizard
Posts: 4373
Joined: Thu Jan 29, 2009 3:54 am
Model of CNC Machine: -CarveWright CNC -ShopBot Buddy PRSAlpha
Location: Brunswick, GA
Contact:

Re: Rustic Welcome Door Plaque

Post by mtylerfl »

Hi David,

You can use a down cut EM instead (if you don't have an up cut EM), but the floor of the pocket will not be as neat and tidy (you'll see more tool mark evidence with a down cut).
Michael Tyler

carvebuddy.com

facebook.com/carvebuddy

-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC

Post Reply