Hi,
I am using Mach3 with VCP and would like to know if there is a difference in using the G-code processor versus the Mach 2/3 processor. When I started learning (before I had Mach3), I was using g-code for everything and just stuck with it after purchasing Mach3.
Should I be using the mach processor now instead of g-code?
Dave
Post processor
Re: Post processor
Hello Dave,
The Mach3 and GCode pp's are very similar and you can certainly
continue GCode version without any worries.
Tony
The Mach3 and GCode pp's are very similar and you can certainly
continue GCode version without any worries.
Tony
Re: Post processor
Great! Thanks Tony!!