Stepcraft M.1000 Post Processors

[NewAtThis]

A change of direction from my RatRig...

Would someone be kind enough to tell me where I can get the latest Vectric V-Carve (v11.5) post processors for my Stepcraft M.1000, please?

I've been watching this Stepcraft video on YouTube....



...and the Stepcraft2 post processors are shown at 9:47 where it is recommended to download the ones provided, but doesn't tell me from where. They are also shown at 9:56. A screenshot from the video are shown below.

Thank you.

[LittleGreyMan]

Hi,

Did you ask your Stepcraft seller?

From the comments of the Youtube video:

This Video explains how to install the Stepcraft-Post Processors on the new Vectric V11 software.
The Multi-Installer is available from your local Stepcraft dealer

[NewAtThis]

Actually, I’ve asked Stepcraft and Vectric Support, but as it’s the Easter holidays and they’re both (understandably) on shutdown, I thought I’d ask here, too.

They don’t appear to be included with the installer I was provided with.

Thanks

[mmelon01]

Did you resolved this issue?