I was looking to see if there was a MM post processor for Camaster. I search the forum here, but did not see anything. THanks in advance!
Shawn
Camaster Millimeter PP?
- SteveNelson46
- Vectric Wizard
- Posts: 2304
- Joined: Wed Jan 04, 2012 2:43 pm
- Model of CNC Machine: Camaster Stinger 1
- Location: Tucson, Az.
Re: Camaster Millimeter PP?
There is one for single tool in the "Owners Only" section of the Camaster forum that Gary Campbell wrote a while back. If you are not a registered owner you will need to contact Camaster.
Steve