I would like to add a line to end of the output fle to move the Z axis to the max Z extents.
"MZ, -1*%(8)" 'move to max z height biased on base table coords
where %(8) is a variable in the Shopbot control software for the Z offset. When this is placed in the pp file, Vcarve Pro will not even open without this error: begin Expected 'begin SECTION' or 'end SECTION' to terminate current section.
How do I put this line in the pp file?
Any help would be appreciated.
Thanks
Todd
Using Shopbot variables in the PP
Re: Using Shopbot variables in the PP
Ug!....
I had the quotes in the wrong place!
"MZ, -1*%(8) 'move to max z height biased on base table coords"
Thanks to everyone who took the time to read this post.
Todd
I had the quotes in the wrong place!
"MZ, -1*%(8) 'move to max z height biased on base table coords"
Thanks to everyone who took the time to read this post.
Todd